Switchboard first
We check the main switch, the circuits and the room left on the board. Upgrades needed for the new load are part of the fixed price, and every new circuit is labelled.
- Board checked
- Upgrade included
- Circuits labelled
Gas heating, a gas hot water tank and a gas cooktop are all common in established Camberwell homes. We plan the swaps as one project, check the switchboard first, and do the work with our own electricians and plumbers.
Home electrification in Camberwell is usually a story about age. A house that has been extended and updated over the decades often has a switchboard from one era, a gas heater from another and a hot water tank from a third. Before any appliance is swapped we look at the board, because it decides how much new electric load the house can take and whether anything needs upgrading first.
From there the swaps are the usual ones: reverse cycle for ducted gas or wall furnaces, heat pump hot water in place of a gas storage unit, an induction cooktop, and then solar, a battery and an EV charger if they suit. Most households do not do everything in one go, so we write one plan that shows the order, what each step needs from the switchboard, and which incentives apply to which item.
Nothing in that plan has to be rushed. The point of having it on paper from the first inspection is that every later step fits, and you stop paying for a gas connection you no longer use once the last gas appliance goes. It is the same approach we take across our Camberwell work.
Every house is different, but this sequence suits most established homes.
We check the main switch, the circuits and the room left on the board. Upgrades needed for the new load are part of the fixed price, and every new circuit is labelled.
Reverse cycle replaces ducted gas or a wall furnace, using Braemar, Mitsubishi Electric or Hisense. New R1.5 ducts are the default on a ducted swap, typically one to two days.
A heat pump replaces the gas storage tank, done by plumber and electrician together, usually in one day. An induction cooktop comes on its own circuit at a fixed price.
Solar and a battery cover the new electric load, and a charger can be added at the same time or later. Each gets its own incentive where one exists.
The full range is on our products page.
Ducted reverse cycle on new R1.5 ducts, or split systems, in place of ducted gas or a wall furnace.
A heat pump in place of the gas storage or instantaneous unit, usually changed over in one day.
The last gas appliance in most kitchens, replaced with induction on its own circuit.
Solar and storage sized for the new electric load, with an EV charger on the same system.
We have no written-up electrification job in Camberwell yet. These three show different starting points.
Across town in bayside Brighton, 19 Jinko panels, a GoodWe system with 16.64kWh of storage and a 7kW EV charger. Heat pump hot water replaced the old rooftop unit, the switchboard moved inside and the house has no gas left.
The gas wall furnace in the hallway was decommissioned and replaced with reverse cycle, alongside Emerald heat pump hot water, 29 Jinko panels, a 27.12kWh SigenStor battery and a switchboard with every circuit labelled.
On the north side of Melbourne, gas ducted heating, gas hot water and a gas cooktop were all replaced by one team: 23.5kW ducted reverse cycle with seven AirTouch 5 zones, Reclaim heat pump hot water and induction.
You can do it in a few days or over a few years. The plan stays the same.
We look at the switchboard, the gas appliances, the roof and where each new unit would sit.
The order of work, what each step needs from the board, and which incentive applies to which item.
Each stage is quoted separately so you can do it in one project or spread it across time.
Electricians and plumbers from one company, so the hot water or heating job is not waiting on someone else.
Circuits labelled, apps set up, compliance paperwork issued, and the old gas appliance removed.
Incentives attach to specific items, not to the project as a whole, so we list them item by item.
The Victorian Energy Upgrades discount applies to reverse cycle heating and cooling and to heat pump hot water, and is largest when replacing gas. STCs also apply to heat pump hot water.
Solar Victoria rebate and interest-free loan apply to panels and inverters only, for eligible owner-occupiers. Batteries get the federal discount of around 30 percent. See heating and cooling in Camberwell for the first step most homes take.
There is no rebate on induction cooktops or home EV chargers in Victoria. Both are a straight fixed price.
Home electrification touches the board, the roof, the plumbing and the ducts. It helps when one company owns all of it.
A-Grade electricians and plumbers on our own payroll, nothing subcontracted.
More than 5,000 Melbourne homes have started on electrification with us.
The board is checked before anything is quoted, and any upgrade is included in the price.
Do it all in one go or stage it, with the plan fixed from day one.
Live Google reviews. Look for the whole-home and off-gas jobs.
Questions from Camberwell households thinking about leaving gas.
With the switchboard check. After that, heating and hot water usually come first because they use the most gas, then solar and a battery, then the induction cooktop.
No. We write one plan and quote each stage, so you can spread the work over time without redoing anything.
We check it before quoting. If it needs an upgrade, that is included in the fixed price and the new circuits are labelled.
We remove and replace them as part of each stage. Once the last gas appliance goes, you can stop paying for a gas connection you no longer use.
A gas to heat pump swap is normally done in one day, with a plumber and an electrician working together.
Braemar, Mitsubishi Electric and Hisense for heating and cooling. Emerald, Reclaim, iStore and Haier heat pumps for hot water. Jinko and Aiko panels, with Sigenergy, GoodWe and other batteries.
Book a free inspection and we will look at the switchboard, the gas appliances and the roof, then write you one plan.